I don’t know if you have heard of it. Medical mobile sliding mats are used to transfer surgical patients smoothly and easily, and to prevent injuries caused by dragging, pulling, and dragging of surgical patients when transferring beds. It especially meets the bed transfer needs of critically ill patients undergoing head, neck, and spine surgeries, joint replacement surgeries, and patients requiring intubation surgeries with high safety requirements who cannot easily access the patient's bed. Next, I will introduce the three major functions of medical mobile sliding mats in detail.

Three major functions of disposable medical mobile sliding pads:

1: Save manpower and material resources. Only 1-2 people are needed to quickly move the patient to the bed. The original bed moving requires 4-5 people to complete, and it requires relatively high arm strength of the bed moving personnel, which is very complicated, but After using the mobile sliding pad, these unnecessary losses can be greatly reduced and the labor force is liberated;

2: Patients cannot move. For example, patients with fractures or patients after surgery may not be touched or moved due to physical pain or drainage tubes after surgery to avoid causing harm to the patient. Secondary hazard, but after using the disposable medical moving sliding mat, we can find that the patient does not need to be moved at all, and the transfer policy can be completed smoothly, which is also very beneficial to the patient;

Three: Secondary risks are effectively avoided. The previous transfer method used multiple people in different positions. Based on the experience of the movers, different sizes were selected for lifting and moving. In this way, the patient was likely to have symptoms of discomfort, and the patient was still moving. It is possible that some carelessness of the moving personnel may cause harm to the patient, but with the medical mobile sliding mat, it is different. It can allow all patients to pass the bed and end the transfer process easily.

We should also pay more attention when using medical mobile sliding mats. For example, the height of the equipment must be adjusted to the same level during transfer. Even if there is a height difference, it should be within 15cm. If there must be a gap between the lathe/bed/table A distance is required and should be within 10cm to avoid unnecessary accidents caused by too far distance.